HydroRocks™
add elegance
and sophistication
to any garden
or landscape.
HydroRocks™, by Russell Watergardens, look and feel like real basalt columns - but with 1/5 the weight! They can be installed anywhere....by hand! No heavy machinery required!
HydroRocks™ are custom made with nylon fiber reinforced concrete over a galvanized steel frame, then acid stained. They are hollow and pre-plumbed with 1 1/2" pipe. They are flat on the bottom with a pipe outlet opening so that they can be installed upright without any footings! Installation is fast and easy.
It's best to install HydroRocks™ in "odd" numbers: 1,3,5,7, and so on. There is minimal excavation, little space required, and the average homeowner or contractor can install them is just a few short hours! All the plumbing lines are hidden from view in the river rock layer.
When they're turned off, all the water disappears into the Hydro Pump Chamber™ and HydroBlox™ under a thin layer of river rock. No standing water!
When the pump is turned on, water bubbles upward out of the top of the HydroRocks™ and cascades down the sides into the river rock layer.
The water passes through the river rock layer down into the HydroBlox™ and then the Hydro Pump Chamber™.
Each HydroRock™ is plumbed with its own ball valve to "dial-in" just the right amount of water flow.
HydroRocks™ are especially attractive at night when they're lit up with LED HydroLights™!
HydroRocks™ by Russell Watergardens are a quick, easy, economical way to add the magic sound of falling water into any garden or landscape!
HydroRocks™ are available in a wide variety of sizes. The more HydroRocks™, the larger the pump should be. Typically, 750 gph - 1,500 gph per HydroRock™ is ideal. An easy "rule of thumb" is approximately 1,000 gph per HydroRock™.
Three HydroRocks™ = an estimated pump flow rate of 3,000 gph.
Franchise Opportunities Now Available