Easy Liner Attachment
Attaching rubber pond liner to HydroClean™
Pond Skimmers and HydroSieves™
is simple, easy, and quick.
The photo on the left shows how liner gets attached to all HydroClean™ Pond Skimmers and HydroSieves™.
All HydroClean™ units feature water inlet pipe nipples. This allows rubber liner to attach to all HydroClean™ units with a simple rubber hose clamp and Stainless Steel band with just one Stainless Steel nut to tighten. No other brand of pond skimmer or pre-filter on the market allows you to install rubber liner with just "one nut".
(For this photo demonstration, we are using a small piece of scrap liner).
Attaching rubber liner to HydroClean™ Pond Skimmers and HydroSieves™ is simple, quick, and easy.
Just extend the rubber liner up and over the front and top of the HydroClean™ skimmer or sieve with about 6" of slack below the inlet pipe.
Loosen the Stainless Steel nut of the Stainless Steel hose clamp and slide the rubber collar over the liner and the end of the inlet pipe.
Fold the liner back over the rubber collar and apply a bead of the included 100% Silicone Sealant around the perimeter of the inlet pipe right next to the liner where it is being held by the rubber collar.
